When I get the 8L here driving teh C6 card properly I will gladly send you the Hal. The C6 wants a really strong signal and getting it all the way out to the C6 has been a struggle. We are also struggling getting a C6 S/D card to run with PP and the Mesa running it out to a BOB. Trouble is a I would rather sling chips than modify undocumented code. Simple but I need to write a script to do it automatically. I am down to save off 4 files then reload the 4 files after updates. The LEAST you have to change the easier it is to UPGRADE versions. So you use their exact setup or learn to mod the code to make YOUR setup work. Then to modify it you have to figure out where it all leads to. The real trouble sometimes is how Tormach routes all its safety functions through about 4-5 moduals. I use the Mesa 7i80 as it has a TON of extra I/O for all the extra goodies we all NEED ( -) You just route the I/O to a different set of pins. IF PP does not see any signal after the spindle is command to start it shuts down the spindle at least on the 8L it does.Īs to 7i92 vs EMC board it is about the same thing only different. I would tap into the actual encoder signal to drive that function UNLESS your VFD has a Freq output for RPM. YEP that is the one it actually uses a freq off of the VFD itself and comes into an encoder pin on the card.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |